24W Led strip lights

Led strip lights

Catalog Number:IC-3528-60WP

Power Consumption:24W

Base Type:

Dimensions (cm):

Product navigation:IC-3528-60WP

	SMD3528\|30	SMD3528\|60	SMD5050\|30	SMD5050\|60
NO IP	IC-3528-30NP	IC-3528-60NP	IC-5050-30NP	IC-5050-60NP
IP65	IC-3528-30WP	IC-3528-60WP	IC-5050-30WP	IC-5050-60WP

smd led strip,motorcycle led,led wall washer,led board

Specification

Catalog Number	IC-3528-60WP
Power Consumption	24W
Luminous Flux (lm)
Base Type
LED Quantity	300pcs LEDs/reel
CRI	75
Beam Angle	180
Color	Daylight White/Warm White/Red/Yellow/Blue/Green/RGB
Input Voltage	DC 12V
Frequency
Net Weight(kg)
Working Temperature	- 20 to 50 Celsius Degree
Dimensions (cm)
Lifespan	Over 50,000 hours
Warranty	36 months
Materials

Inquire Now

How To Darken Your Tail LightsIf you are interested in modding your vehicle, tinting your tail lights can be one of the easiest and most effective mods for the amount of time and money spent. I have completed this mod on my 2009 Chevy HHR and it turned out GREAT! There are a few important steps to follow, so please read all of the steps completely before you begin this mod. First off, you need to decide which lights you are going to tint. I have tinted the side marker lights, rear reflectors, and tail lights. You will need some fine grain sand paper, starting at 600 grit, up to 2000 grit. Get atleast 3 different sizes, the more the better. You will also need a can of VHT Night Shades tinting paint. This is available at most auto parts stores in a spray can, and is very cheap, usually under %15 for the can. You will also want a can of spray on clear coat, to seal the lights you spray. Once you have your supplies, you can either remove the lights your are spraying from the vehicle, or mask off the entire area around each of the lights you want to tint. On my Chevy HHR I removed the rear side markers and tail lights, and masked off the rear reflectors and front side markers. You do not want any overspray on your paint so mask as much as you can! First you need to sand down the lenses. Start with the roughest grit, and wet sand down until you get to the 2000 grit. Lightly sand only, as you are basically trying to create a good surface for the tint to adhere to, while removing wax and any coating on your lenses. Now that your sanding is complete, completely clean the lenses with rubbing alcohol and let them dry. Make sure there are no fibers or stray material on them, this is crucial! Grab your can of VHT Night Shades and apply your first light coat. After this initial coat dries, re-apply this step until you reach the darkness you prefer. If tinting your headlights (This may be illegal in some states and provinces), I would never go more than one or two very light coats. Once you are completed tinting, you can apply up to three coats of clearcoat. This will help protect the lense, and ensure that the tint you have applied will not wear off. Now, after your tinting and clearcoating has finished drying, you can either re-install the lights or unmask the area around your tinted lights. Take your vehicle for a drive and enjoy your easy mod. I had the lights on my Chevy HHR tinted all in a saturday afternoon. Just make sure you complete your prep work the proper way, and your end result will look great! ...

24W Led strip lights

Led strip lights

Product navigation:IC-3528-60WP

Specification

Inquire Now

Please leave message

Inquiry Online

Hot Application